fd5628e5dc
This configuration builds an image for the Compute Module 5 IO Board. Note: Unlike the Raspberry Pi 5 and its dedicated debug uart connector, the kernel console on Compute Module 5 IO Board is back to UART0 (ttyAMA0) on PIN8 (GPIO14, TX, yellow) and PIN10 (GPIO15, RX, orange) on the 40-pin header, as the former version of the Raspberry Pi. Signed-off-by: Gaël PORTAY <gael.portay+rtone@gmail.com> Signed-off-by: Julien Olivain <ju.o@free.fr>
25 lines
759 B
Plaintext
25 lines
759 B
Plaintext
# Please note that this is only a sample, we recommend you to change it to fit
|
|
# your needs.
|
|
# You should override this file using BR2_PACKAGE_RPI_FIRMWARE_CONFIG_FILE.
|
|
# See http://buildroot.org/manual.html#rootfs-custom
|
|
# and http://elinux.org/RPiconfig for a description of config.txt syntax
|
|
|
|
kernel=Image
|
|
|
|
# To use an external initramfs file
|
|
#initramfs rootfs.cpio.gz
|
|
|
|
# Disable overscan assuming the display supports displaying the full resolution
|
|
# If the text shown on the screen disappears off the edge, comment this out
|
|
disable_overscan=1
|
|
|
|
# enable RTC
|
|
dtparam=i2c_vc=on
|
|
dtoverlay=i2c-rtc,pcf85063a,i2c_csi_dsi
|
|
|
|
# enable dwc2 USB controller (USB 2.0)
|
|
dtoverlay=dwc2,dr_mode=host
|
|
|
|
# Enable UART0 for serial console on ttyAMA0
|
|
dtparam=uart0_console=on
|